Search results

I know this has been discussed but I can't seem to find a tutorial specific the the S10 on how to JUST change the cam chain tensioner. At some point I will tackle a valve check but for now all I want to do is put in the upgraded tensioner. Even the service manual isn't clear on how to change it...

2012 with about 26K on it. No issues till this morning. Started fine. Blipped the throttle and it stumbled and the check engine light came on...no throttle response at all. Turned it off and restarted fine. Revved it and it seemed okay. Took off for work and it was fine until I got to the...

I installed the Novasight H7 bulbs and 3D printed my own caps but the caps hit the forks near full lock. Am I the only one experiencing this? I can't see making them any shorter or the bulbs won't fit.

I needed to replace the footrest on the left side of the bike as the result of a drop. Going through the parts list there is only a pin ( bolt) on the bottom of the left footrest. I was wondering why they put it on only the left side? Whats the purpose? Part #23 in the diagram.

Since I have switched to soft panniers for travel I have noticed my passengers handles getting a little scuffed where the bags rub. Solutions I am considering. Clear box tape Paint Protection film, like they use on car door sills Gaffer tape and just remove when not travelling. Any other ideas?

$400 plus shipping to USA. Near new condition, very little road time. Does NOT include MOLLE panels. Includes all original hardware. Fits most pannier racks. See moskomoto.com for fitting info. To aid in shipping estimate to your ZIP code, box is approx. 14.5 lbs and is 16x16x10 inches. Located...

Tickets available here https://www.eventbrite.com/e/north-...documentary-film-and-talk-tickets-92779844011 The Central NH/VT Riders would like to cordially invite you to a showing of Backcountry Discovery Routes' latest film showcasing the epic adventure known as the Northeast BDR. This route...

I just installed the MC Cruise this past weekend on my 2012 and the weather was warm enough to give it a test. The unit passed all the diagnostics in the garage, however when out on the road it kept disengaging after anywhere from 2-30 seconds. The speed wasn't to fast around 40PMH. I contacted...

Was on my 2012 not sure if it will fit the Gen 2 bikes. Model number is YAM630. In Excellent condition, switching to electronic cruise control. Works as advertised. $100 including shipping to the lower 48 USA.

I just installed thiws and not sure I have it adjusted correctly. Seems I keep engaging the lock when I don't want to. If I loosen it up to the point it doesn't do this I have to make almost a full turn before it begins to snug up and hold the throttle. If I adjust it so I can activate it as...

My left fork seal started leaking....bad enough to leave a small stain on the ground when parked. I tried using a seal saver b ut it started leaking again. I assume this would be covered under the YES warranty? Any other ideas to fix it. Dealer is an hour away so kind of a PIA so take it in....

on a 2012 Is there a n adjustment for the clutch? I noticed this morning the clutch is grabbing near the end of the lever throw. In other words I don't have as much slip range and I use to. The clutch itself when engaged does not slip. Could it possibly need a flush? I did one about 5K miles ago...

SOLD 2006 Keystone Hobbi Model HB220 Located in Enfield, NH $6,000 No Trades Dinette and sofa fold down to create beds. In good condition. Aluminum rims Walls are constructed of welded aluminum with fiberglass exterior. A/C Gas Furnace Refrigerator Freezer (gas and Electric) Hot water...

I just installed a set of Shinko 705s and the front took a lot of weight. 3oz. I will admit the Dot was not placed correctly, well it was when I started to mount the tire but apparently it shifted so its about 6 inches off from the valve. I can't believe it would make that huge a difference...

While changing tires I noticed an issue with one of the drive bushings. The small piece of rubber that connects two of the wedges had broken. Do I need to replace this or can I just put it back in and not worry about it? Thanks

Trying to thin out the equipment I haven't used in a while. Up for Same is a Nemo Morpho 1P tent in excellent condition. Lightly used included ground sheet. Located in Enfield New Hampshire. Will ship within in the US USPS Parcel post for free. Any other method will be at buyers expense. $200...

Just got back a few days ago from Nova Scotia... Here is a pic of my track... 2440 miles in 7 days. I did 600 miles in one day on the way back.. The S10 performed perfectly as expected. A few pics from Cape Breton and the Cabot Trail...

So as a joke I re-posted a Goldwing for sale to my wifes Facebook page asking if I could have one....well the response was't what I was expecting.... She said If I get one of those she would ride with me....she doesn't like to ride pillion on the S10. So after making it clear I wasn't getting...

I know I read of this happening to someone else..... Today on my ride to work I noticed a new rattle...once I got to work on quick inspection the two forward bolts holding the SW-Motech top rack snapped. The thing that aggravates me is I don't really keep much in the top box. I use it mostly to...

SOLD! SPOT Gen 2 excellent condition no current contract on it. Includes to two cases, one with arm band one that floats. Plus RAM Mount. $50 will ship anywhere in the US for $5 PM me if interested....Located in Enfield NH