Search results

I have bypassed rear brake as i lost pressure, now this winter i will ship abs unit to diag in france for rebuild. i cant find out how aba unit is attached if i see under tray there are two circular slots but cant se it is bolts there. i can also see a little bolt on the left side of tray...

Thanks for feedback on process with Diag. 2024 season in Norway is almost over. I will demont and ship abs unit to diag before christmas. Hope abs will be working for next season. Yamaha XT1200ZE MY 2014 KTM 690 Enduro R, MY 2009 KTM 690 Enduro R, MY 2022

Same happened to me last season 2023, i have by passed rear abs and removed fuse for abs pump as the front brake also was spongy. i now have god brakes without abs. I also would like to repair abs and think i will ship this winter to...

Have same problem on a 2014, think i will copy your solution for this season 2024 Maybe send abs unit for repair to uk or france when winter is comming.

All good now with new stay mounted, stay was cracked on top and bottom at mounting bracket due to vibrations over year on gravel roads.

ups...did you weld it?

yes, will do. :)

Thanks bimota, seems i easily can fix this myself

Part stay 1… 23P-28356-01 Have someone changed this part? is it a job feasible to do self made.

-59 still stiff like a pole, in my opinion perfekt combo yamaha xt1200ze and ktm 690 enduro r

I have finally put in new spark plugs and cleaned coils, sealed with special silicon "heatproof" checked resistance in coils and put everything back together after 5-6 months with stand still due to winter. Bike started after 2 short push on stater, and engine started and was idling as it...

Ktm 690r is absolutely an enjoyable bike, enormous power and moment for single piston engine. Not any special year to avoid, but 2009-2010 have longer travel on suspension. Mine is 2009 i also use it in winter on snowy and icy roads not salted.

Thanks, no codes displayed..

Hi I have now installed new plugs cpr8eb-9. Old ones at picture, the coils and plugs looked just as shabby a year ago, when I changed plugs for the first time about 40,000 km. I have started with what I can do myself, and i suspected periodic error in a coil, I have measured the coils several...

agree this plug is only 12 months old, all 4 seems the same. Everything cleaned well at that time, all rubber sealing checked and so on. there are 2 small slots in every sealing i guss that is for escaping water/steam. All 4 is now new and coils is measured to spec ohm value. have to put all...

I am a gravel junkie, so water and sand/dust is all over my bike. Bought this bike new in 2014 and have 47000km on it, also have a ktm 690 enduro r.

that was also strange no engine codes or engine lamp seen when this happen, i can maybe have overseen this but i am almost sure there was no. Because me and my mc buddy talked abut that on the trip, that it was strange i could not see any codes or engine lampe lit up.

engine cheats, pops and does not pull, it sounds like it is running on only one cylinder. it can suddenly for a few seconds go normal, i have checked coils with ohm meter and all 4 is in spec. Any sensor i can check with multimeter? Had to bring bike home on a trailer. At one point at a stop it...