Search results

@Checkswrecks How does the weight feel compared to the S10. I'm getting older and am looking to reduce bike weight, but still need something sizeable as I'm 6' and 260 lbs, with short 29" inseam.

Can you get them on over Adventure style boots, is the leg opening wide enough?

Which CPAAT are you doing? Nothern or Southern route? I did from Colton Point SP to Erie last week on the Nothern. Nice ride. I did hit one section where there was a sign syaing, "Do not enter, Not the GPS route!". I didn't want to get shot at so I bypassed it on the hard road. If you happen...

850 miles through Pennsylvania. MABDR and CPAAT ending at Lake Erie, then 300 miles of slab back home. Great 2 1/2 days!

Nice! I'll be doing some of the MABDR Sunday and Monday, then the CrossPA Adv Trail to Erie on Tuesday.

Made me look again!

E07+ ?

New front. Heading out for 4 days on Sunday. Back was new 1000 miles ago. 40 min tire change with spoons and a bucket for a stand. I'm getting better at this.

I made a set of something similar a couple years ago out of a old plastic waste bin. They worked well and I still have them. I have since used the 3d printed ones from @deftoner , they work great as well. I love seeing the awesome ideas that people come up with. Kudos to the OP!

Sending PM

Are these built to a specific weight like Russels? And if so, what weight was this built for? I'm 260lbs so...

2nd in line if it's not sold to @AusTexS10

Rubber deteriorating on your heated grips? Don't spend $100 on new grips! Install Grip Puppies™️ for $19.95! Maybe my gloves won't stick to the grips anymore...ewww!

I would have to assume the hoses were replaced also? That is a common problem on automobiles. The hose degrades internally and will not allow fluid to pass. I have experienced this mostly with dics brake calipers.

Mounted up a Mitas E07+ for the rear. I'm getting good at the tire change thing. My new high tech tire changing stand worked well. Also torqued the spokes. About half of them were under torqued.

Early S10 Kaoko Install Instructions

Yes. Original screw. It replaces the bar end weight on that side.

Bumpity-bump. This is genuine, not a knock off. New ones are $145!

Came off a 2012 Super Tenere. Just too fiddly for me. WYSIWYG. $50 shipped CONUS from PA, 17241.

4 screws to take off the headlight shroud. 4 10mm head bolts to loosen the headlight bucket. Pull the bucket forward to get to the bulb sockets. Old builds out #194 LED bulbs in. Easy peasy.