Recent content by Ramwyn

  1. Ramwyn

    *SOLD* ALTRider Crashbars For Sale (UK)

    I'm afraid I sold them a couple of weeks ago on ebay, yoyo. Sorry, but I forgot to update this site.
  2. Ramwyn

    *SOLD* ALTRider Crashbars For Sale (UK)

    Please note these are for UK delivery only.
  3. Ramwyn

    *SOLD* ALTRider Crashbars For Sale (UK)

    I'm selling a set of ALT Rider crash bars for the Yamaha XT1200Z. I sold my Super Tenere last year and am having a garage clearout - these are next to go. They are without doubt the best bars on the market for the big XT and are far more robust and higher quality than others out there. Freshly...
  4. Ramwyn

    Bits For Sale (UK).

    Offers anyone?
  5. Ramwyn

    Bits For Sale (UK).

    Having a bit of a garage clearout and have got the following to sell: Slimmer Seat pads (rubbers) Part No. 116-24741-00. Theses are to do the seat mod (leveling of seat - a lot more comfortable). As new. Blanking rubbers to plug grab rail mounting holes in plastic panel. As new. Gen 1 Owners...
  6. Ramwyn

    What you did to your Tenere today??!!

    Finished adapting then fitted a Remus Hexacone to my Gen 2. I bought it used from a fellow owner (who had it on his Gen 1) without realizing the flange fitting was different. Dohh! After some initial swearing and cursing, I set to with my angle grinder. I turned a new flange on the lathe, cut...
  7. Ramwyn

    Cat removal on my '17 ST " how to"

    Well done on the how-to. I've been thinking of exhaust mods myself, either de-cat or different silencer so I'm looking forward to hearing how the bike performs after this mod.
  8. Ramwyn

    Jumpy Throttle fixed

    No error codes have shown up since I removed the sensors, MPG seems unaffected and it doesn't seem to have caused any issues. So far so good. :)
  9. Ramwyn

    Jumpy Throttle fixed

    Just thought I'd chip in with the solution that worked for me........ I removed the TPS and cleaned it out using contact cleaner and compressed air, whilst rotating the shaft. Disappointment later followed when my test ride revealed this had not cured the snatchy throttle (at 2-3000RPM). I...
  10. Ramwyn

    Jumpy Throttle fixed

    Is this fix applicable to both Gen 1 and 2 bikes? I've tried just about everything else to try and cure the jumpy throttle and lack of deceleration at low RPM. This includes ECU remap, TB screw adjustment + synch, CO increase, and throttle cable free-play reduction. It's spoiling what is...
  11. Ramwyn

    Gen2 Windscreen brackets to stop vibrations **SOLD OUT**

    Hi Tom, I've just sent you $40 for the screen stays. Look forward to receiving them so I can see my GPS in a non-blurry state!
  12. Ramwyn

    Hi Proposto. Just fitted a Garmin Zumo 660 to the accessory bar of my 2014 S10, After realizing...

    Hi Proposto. Just fitted a Garmin Zumo 660 to the accessory bar of my 2014 S10, After realizing how much it bounced about, I did a search and found out about your great brackets. Could you give me details so I can order some via Paypal please? Thanks.
  13. Ramwyn

    diagnostics and codes...

    Hi there folks. I've just done a fault code check in the Diagnostics menu and along with codes 14 and 30 which I am familiar with, it displays code 89. From eemsreno's previous post, he describes it as "Signals cannot be transmitted between the Suspension Control Unit and the ECU and between the...
  14. Ramwyn

    Snatchy throttle problem (with remap)

    I went for a test-ride yesterday, the weather was quite pleasant and Spring-like. On my route of around 150 miles I had a good proportion of little single track roads planned - plenty of opportunity to see how the low speed throttle response would be. The verdict is that after the Throttle...
  15. Ramwyn

    Snatchy throttle problem (with remap)

    No maybe not, but I would expect some difference between the modes, which mine hasn't got.
Top