Recent content by Clawdog60

looks like I will be digging through the loom to find molex connectors for testing. Doesn't appear to be an enjoyable task

yes engine on

I don't have the shop manual for a wiring diagram for test points. I will see if I can find a wiring diagram

I have no power at the plug. I marked + with red paint and tested + side of wiring before bulb install

yes. light works fine on right side hi and low beam swapped bulb and checked with meter ;same no power

Was working fine. Installed oxilam led and only right side works. Tested power and bulb. No power at connector. 2017 model. common problem? Easiest point to test without removing headlight bucket?

I will check the balance of mine if I ever have to replace it

Are deep caps available by themselves?

I have a rear mutant at my door today. Unfortunately it will be spring before I get to try it:( I thought the tread looked good for mild trail/gravel I hope the mileage is above average.

I would have it balanced if possible; plates springs basket together

I'm going to try the mutant those trail.......way too expensive for the longevity

I did. Tired of replacing junk sylvania bulbs. I did order the oxilam 6k bulbs. Will see how that works

Which led did you buy? did you get them installed yet? If so what is your evaluation on fit and performance? Thanks

Glad I didn't waste my money on cyclops

Will the shengda led fit under the stock dust cap? I'm getting tired of replacing bulbs.