maverick2076
Active Member
Can anyone point me to some installation instructions for the OEM side cases? I bought a set off a poster here and need to find some install instructions.
Disassembly can be measured, armed is difficult because it enters inside the handles and you cannot see how much it enters. if you zoom the pic on monitor computer until the size of the screws conicide with the screws you have, next to these are spacers they should give you the measure, you can do it from some black polymerI bought a used set but missing the part # 17 and 18 spacers. Anyone have a size/ spec on those so i can source generic locally? Thanks!
That's a pretty good idea. Never would of thought of that on my own.Disassembly can be measured, armed is difficult because it enters inside the handles and you cannot see how much it enters. if you zoom the pic on monitor computer until the size of the screws conicide with the screws you have, next to these are spacers they should give you the measure, you can do it from some black polymer
View attachment 63128
Awesome, if my logic is sound, the front is a 5/8" spacer and the rear is 1" spacer. I added the thread depth of the factory bolts to the stack of bushings and brackets, and then subtracted from the longer bolt lengths. Curious to see how far off I am.I have the spacer's dimensions but it is at the office. I'll get it tomorrow.
An error of 9,92% in the long and 1% in the short, being the first time, not badAwesome, if my logic is sound, the front is a 5/8" spacer and the rear is 1" spacer. I added the thread depth of the factory bolts to the stack of bushings and brackets, and then subtracted from the longer bolt lengths. Curious to see how far off I am.
Same question but regarding ZE version. As you know the right handle is occupied with compressor. Any guide for ZE available?Can anyone point me to some installation instructions for the OEM side cases? I bought a set off a poster here and need to find some install instructions.
There's no difference in the mounts between the standard and ES models, at least through the '15 model that I have.Same question but regarding ZE version. As you know the right handle is occupied with compressor. Any guide for ZE available?
I used this instruction for my 2019 ES. Good luckSame question but regarding ZE version. As you know the right handle is occupied with compressor. Any guide for ZE available?
Muchas Grazias SenorI used this instruction for my 2019 ES. Good luck
Well, thanks very much for that info.no,
i had handles on mine when i had standard cases, sold them off for givi, but the handles where the bolts go threw have deep holes in them for spacers and bolts etc they fit fine,
if you look at the instructions that lemmifun put on above the last picture on the top right top layer shows how the grab handles and fitting bar go on with bolts and spacers
rob