Jlq1969's latest activity
-
Jlq1969 replied to the thread Africa Twin.Which size do you not like about the AT, the previous 21”…or the new 19”? -
Jlq1969 Yes I found it pretty frustrating that the on board dash diagnostics along with turning the back wheel showed the rear sensor...
-
Well gentlemen, the time has come for my beloved 2016 ES, aka Godzilla, to move on. I have recovered somewhat from my bout of CKD, but I...
-
Jlq1969 replied to the thread What you did to your Tenere today??!!.I think it's not a problem. It is normal to find this type of wear on a tire with knobs. On the rear tire, it is normal for it to occur...
-
Jlq1969 replied to the thread 2013 ABS issue.Although the speedometer and ABS use the same sensor, the information obtained from the sensor is used in different ways. For the...
-
ABS failure resolved So after many days of trouble shooting and diagnostics of the fault code causing the ABS to be inoperative it has...
-
Jlq1969 reacted to Checkswrecks's post in the thread Monster KTM 1190 dirt bike with 46" Mickey Thompson tires with
Like.
Can it hill climb and jump? I be afraid of throwing that chain into the back of my leg! Article... -
Jlq1969 replied to the thread This Ain't Good | 2024 with 375 miles.Try adjusting the throttle cable. By doing so, the coordination between the clutch and the accelerator is improved...you have a small...
-
Jlq1969 replied to the thread S10 Hella3 conversion.I'm not going to pass on links, because I'm not sure what I'm seeing...but I "think" that the S10's magnifying glass is not bad. I have...
-
-
Jlq1969 replied to the thread Hola desde Argentina!.welcome!!!…..how many km does it have?
-
Jlq1969 replied to the thread 2013 ABS issue.And the wheel sensor rotor?…the SS manual indicates a minimum tolerance
-
-
-
picked the bike up after being in the garage for 4 weeks, McCRUISE now fitted and working perfectly, new map sensor most of you know...
-
I think a lot of us on the forum are in that 50 plus age range, so this is a good place to post this. About a year and a half ago, I...
-
Jlq1969 replied to the thread Valve shim adjustment?.I don't think the shim falls directly into the crankcase...above the crankcase are the oil pump and the counter-rotating shaft...
